Mosfet micro active brake II Jefftron

Mosfet micro active brake II Jefftron

Attention! Warranty is not provided for mosfets installed outside our service center!

This mosfet is specifically designed for electric airsoft guns, featuring an active brake for the motor. In semi-fire mode, the piston is not partially drawn, the spring is fully released, and the mechabox parts are not under tension, while the nozzle blocks the hop-up chamber to a greater degree (depending on ROF). The active brake resolves the issue of multiple shots in semi-mode, especially for guns with a very high rate of fire (ROF). Additionally, this device increases the gun's rate of fire and prolongs battery life compared to standard wiring.

Specifications:

- Compact Size: The mosfet's very small dimensions allow it to fit almost anywhere.
- No Wiring: Power cables up to 1.5 qmm (AWG16) and signal cables of 0.5 qmm (AWG20) can be used.
- Installation Options: Suitable for service centers; if you lack experience in soldering circuits, choose the version with cables and accessories included.
- Spring Compatibility: Designed for springs up to M160 (equivalent to a current of 75A for single fire or 25A for burst fire for up to 30 seconds).
- Battery Compatibility: Suitable for common batteries up to 17V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V).
- Active Brake: Uses excess motor energy to stop it, with the braking effect strongest on motors with high torque.
- Connections: Features a 6-wire connection.
- Dimensions: 27x10x7mm.
- No Idle Consumption: There is no current draw in idle mode.
- No Sparking: No sparks occur on the switch contacts.
- Auto Mode: In auto mode, the piston stops at random positions due to the mechabox design.
- Proper Functioning: A functional stop lever in the gearbox, selector plate, reverse latch, trigger, and trigger block are necessary according to gearbox standards.

Package Includes: Micro Active Brake Mosfet II Jefftron, Heat Shrink Tubing, Installation Manual in English.