Mosfet II with wiring Jefftron

Mosfet II with wiring Jefftron

Attention! We do not provide a warranty for MOSFETs installed outside our service center.

This MOSFET is specifically designed for electric airsoft guns, enhancing firing rate and battery life compared to standard wiring.

Specifications:

- Easy Installation: Pre-soldered wires enable faster and easier installation in all types of guns. Simply cut the wires to the desired length and attach the included connectors.
- Quality Wiring: The MOSFET comes with four 1.5qmm (AWG16) power cables covered with PTFE insulation and two 0.34qmm (AWG22) signal cables.
- Water Protection: The board is coated with a conformal layer to protect the device against water.
- Wire-Free Option: If you prefer to use your own cables, select the wire-free version.
- Spring Compatibility: Designed for springs up to M210, equivalent to 150A single-shot or 50A burst for up to 30 seconds.
- Battery Compatibility: Suitable for common batteries up to 17V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V).
- Connection: 6 wires.
- Dimensions: 25x12x7mm.
- No Idle Consumption: No current draw in idle mode.
- Spark-Free: No sparks on the switch contacts.
- Auto Mode: In auto mode, the piston stops in random positions due to the mechabox design.
- Proper Functioning: A functional stop lever, selector plate, trigger, and trigger block are required as per gearbox standards.

Package Includes: MOSFET II with Jefftron wiring, Male DeanT connector, 30A mini fuse, 4x female Faston connectors 2.8mm, 6x black heat-shrink tubes 3.2mm (20mm length), 3x black heat-shrink tubes 4.8mm (20mm length), English installation manual.