Mosfet V2 with wiring Jefftron

Mosfet V2 with wiring Jefftron

Warning! We do not provide a warranty for MOSFETs installed outside our service center.

This MOSFET is specifically designed for electric airsoft guns to increase the rate of fire and extend battery life compared to standard wiring. It is fully integrated into the Version 2 gearbox, replacing original trigger contacts, and is compatible with Tokyo Marui standards.

Specifications:

- High-Quality Construction: Built using trigger contacts from SHS.
- Easy Installation: Simple to install inside the Version 2 gearbox.
- Pre-Soldered Wires: Comes with pre-soldered wires for easier installation in your weapon, with sufficient length for any type of gun. Simply cut the wires to the needed length and attach the connectors (included in the package).
- High-Quality Wires: Includes two black 1.5 mm² (AWG16) wires with thin, durable MPPE insulation, 300 mm length for the motor and 700 mm for the battery. A blue 0.34 mm² (AWG24), 1000 mm wire is used for connection anywhere on the red wire.
- Wiring Options: Designed for rear wiring but can be front-oriented if the battery's black wire is resoldered on the board.
- Water Protection: The board comes with a protective coating against water damage.
- Wire-Free Option: Choose the wire-free version if you prefer using your own wires.
- Spring Compatibility: Designed for springs up to M170 (equivalent to a current of 90A on single fire or 35A on burst fire for up to 30 seconds). For higher loads, use MOSFET II (which is external to the gearbox).
- Battery Compatibility: Suitable for common batteries up to 17V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V).
- No Current Drain in Idle Mode: There is no current drain when idle.
- Spark-Free: No sparks on the switch contacts.
- Auto Mode: In auto mode, the piston stops in random positions due to mechabox design.
- Proper Operation: A functional cutoff lever, selector plate, anti-reversal latch, trigger, and trigger block are required, following gearbox standards.

The package includes: the MOSFET V2 with Jefftron wiring, a trigger switch, a screw for MOSFET attachment, a male DeanT connector, a 30A mini fuse, four 2.8mm female faston connectors, six black 3.2mm heat shrink tubes - 20mm length, three black 4.8mm heat shrink tubes - 20mm length, and an installation manual in English.