Mosfet active brake II with wiring Jefftron

Mosfet active brake II with wiring Jefftron

Warranty Disclaimer: We do not provide a warranty for MOSFETs that are installed outside of our service center.

This MOSFET is specifically designed for use in airsoft electric guns and includes an active brake feature for the motor. In semi-automatic mode, the piston doesn't remain partially cocked, the spring is fully released, and the mechabox components aren't under tension. The nozzle blocks the hop-up chamber more effectively, depending on the rate of fire (ROF). The active brake feature solves the issue of multiple shots in semi-auto mode, particularly for guns with a very high rate of fire. It increases the firing rate of the airsoft gun and extends the battery life compared to standard wiring.

Key Specifications:

- Pre-Soldered Wires: The mosfet comes with pre-soldered wires, enabling quicker and easier installation into the airsoft gun. The wires are lengthy enough for all airsoft gun types, and they can be cut to the desired length, with connectors included in the package.
  
- High-Quality Wires: Includes four power wires of 1.5 mm² (AWG16) with MPPE insulation and two signal wires of 0.34 mm² (AWG22).
  
- Water-Resistant Protection: The circuit board is coated with a conformal layer, offering protection against water.
  
- Wire-Free Option: If preferred, you can use your own wires by choosing the version without included cables.
  
- Spring Compatibility: Designed for springs up to M210 (equivalent to a 150A current for single shots or 50A for bursts lasting up to 30 seconds).
  
- Battery Compatibility: Compatible with batteries up to 17V (Ni-xx 8.4 - 12V, LiPo 7.4 - 14.8V).
  
- Active Brake: Utilizes excess motor energy to stop it. The braking effect is strongest with high-torque motors.
  
- Connections: Features a 6-wire connection system.
  
- Dimensions: 35x12x7mm.
  
- No Idle Current Consumption: There is no current draw in idle mode.
  
- Spark-Free: No sparks on the switch contacts.
  
- Auto Mode Performance: In automatic mode, the piston stops at random positions due to the mechabox design.
  
- Correct Operation Requirements: A functional cutoff lever, selector plate, anti-reversal latch, trigger, and trigger block are necessary according to gearbox standards.

Package Includes:  Mosfet active brake II with wiring Jefftron, Male DeanT Connector, 30A mini fuse, 4x 2.8mm female faston connectors, 6x black heat shrink tubes 3.2mm - 20mm length, 3x black heat shrink tubes 4.8mm - 20mm length, Installation manual in English.