Titan V2 Basic Module Rear Wired Drop-in Gate

 Titan V2 Basic Module Rear Wired Drop-in Gate

This module is set to fire on SEMI AUTO only.
Reprogramming to Full Auto is not possible.

Package Includes:
MOSFET TITAN V2 BASIC with rear wiring
Installation kit
Installation guide

NOTE! This module is not complete. It needs the USB-Link Gate Programmer SKU: 6343 to work.

NOTE! We do not offer a warranty for mosfets mounted outside of our service!

TRIGGER SENSITIVITY ADJUSTMENT - allows you to control trigger sensitivity. You do not have to disassemble your AEG.

CONFIGURABLE FIRE SELECTOR (gen.2)

CYCLE DETECTION - detects in which position the cycle must stop, even the shortest trigger action produces at least one full cycle.

PRE-COCKING (gen.2*)
Thanks to PRE-COCKING, you gain a trigger reaction similar to a real gun. It allows for initial spring compression, which speeds up the trigger response significantly.

ROF STAB
It allows you to change the way the ROF Control works:
ON - ROF Control uses PWM to decrease ROF. Thanks to this gearbox works smoothly what decreases wear and tear of AEG internal parts.
OFF - ROF Control adds breaks between shots to decrease ROF. It gives you more realistic experience.

SNIPER DELAY
It lets you to set delay between each SEMI shots to simulate the delay from reload or recoil. You can set 0.5s, 1s, 2s or 3s delay.

SMART TRIGGER
It enables you to achieve a faster trigger response. It works with the ROF Control System. During the first shot, the microprocessor sets the ROF Control to 100%. After the first shot, it switches to a previously programmed value (e.g. 50%). As a consequence, the first shot is fired at a full ROF, and subsequent shots at a reduced ROF.

BATTERY PROTECTION (gen.2*)
Protection against Over-Discharge of the Battery.The microprocessor monitors the battery voltage constantly. When the voltage drops down to a critical level, it will not allow firing.

SMART FUSE
A combination of current, voltage and temperature measurements makes your AEG installation highly reliable. It protects the MOSFET against overheating, overloading and short-circuiting.

MOSFET
It targets the energy from the battery directly to the motor, bypassing the mechanical trigger contacts. As a result, you gain a higher ROF of the gun and a faster trigger response.

BUILT-IN SELF-TEST

This allows you to quickly check whether the drop-in module is working properly. It helps to locate where the problem lies when anything goes wrong.

COATING

Thanks to its special conformal coating, our product is resistant to atmospheric conditions (Military Specification MIL-V-173C).